Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUZUKI2013SX4 CROSSOVER, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 58 (GENERAL INFORMATION)GENERAL DESCRIPTIONVEHICLE LIFTING POINTSWHEN USING FLOOR JACK
2013 Suzuki SX4 Crossover, Automatic CVT Trans
When Using Floor Jack
2013 Suzuki SX4 Crossover, Automatic CVT TransSECTION When Using Floor Jack
WARNING: This page is about a different car, the 2011 Suzuki SX4. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Improperly raising only the front or rear of the vehicle with a jack could cause serious personal injury and/or damage to the vehicle.
- Before jacking up a vehicle only at the front or rear end, be sure to block all the wheels that will remain on the ground.
- After the vehicle is jacked up, be sure to support it on safety stands. It is extremely dangerous to do any work on the vehicle supported by a jack alone.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.