Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUZUKI2013SX4 CROSSOVER, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 5 (CELLULAR/ENTERTAINMENT/NAVIGATION/AUDIO)SCHEMATIC AND ROUTING DIAGRAMSECONDARY/CONFIGURABLE CONTROL CONNECTOR END VIEWSSTEERING WHEEL CONTROL SWITCH - LEFT
2013 Suzuki SX4 Crossover, Automatic CVT Trans
Steering Wheel Control Switch - Left
2013 Suzuki SX4 Crossover, Automatic CVT TransSECTION Steering Wheel Control Switch - Left
WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.
Connector Part Information
OEM: 30700-1100
Service: -
Description: 10-Way F HDAC64 DR Series (GY)
NAVIGATION SYSTEM DESCRIPTION AND OPERATION - STEERING WHEEL CONTROL SWITCH - LEFT
| Pin | Wire Color | Circuit No. | Function |
|---|---|---|---|
| 1 | PU | 1375 | Remote Radio Control Supply Voltage |
| 2 | - | - | Not Used |
| 3 | GY | 1884 | Cruise Control Switch Signal |
| 4-5 | - | - | Not Used |
| 6 | PU/WH | 7005 | LED Dimming Signal |
| 7 | - | - | Not Used |
| 8 | BK | 1450 | Ground |
| 9 | GN/WH | 7158 | Cruise Control Indicator Dimming Signal |
| 10 | - | - | Not Used |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.