Radio Rear Speaker Replacement

2013 Suzuki SX4 Crossover, Automatic CVT TransSECTION Radio Rear Speaker Replacement
WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Radio Rear Compartment Speaker Bolts & Nuts
G04843276Courtesy of SUZUKI OF AMERICA CORP.
RADIO REAR SPEAKER REPLACEMENT REFERENCE

Callout Component Name
Preliminary Procedures
Remove the right rear quarter lower trim panel. Refer to REAR QUARTER LOWER TRIM PANEL REPLACEMENT .
1 Radio Rear Compartment Speaker Bolt (Qty: 2)
CAUTION: Refer to FASTENER NOTICE .

Tightening torque 
2.5 N.m (22 lb in) 
2 Radio Rear Compartment Speaker Nut (Qty: 2)
Tightening torque 
2.5 N.m (22 lb in) 
3 Radio Rear Compartment Speaker
Procedure 
  1. Disconnect the electrical connectors.
  2. Transfer the amplifier assembly to the new speaker.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.