SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUZUKI2013SX4 CROSSOVER, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 46 (BODY STRUCTURE)REPAIR INSTRUCTIONSREAR BUMPER LOWER FASCIA REPLACEMENT
2013 Suzuki SX4 Crossover, Automatic CVT Trans

Rear Bumper Lower Fascia Replacement

2013 Suzuki SX4 Crossover, Automatic CVT TransSECTION Rear Bumper Lower Fascia Replacement
WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Rear Bumper Lower Fascia Components
G04843073Courtesy of SUZUKI OF AMERICA CORP.
REAR BUMPER LOWER FASCIA COMPONENTS REFERENCE

Callout Component Name
Preliminary Procedure 
Remove the plastic retainers and the bolts securing the rear wheelhouse liner panels to the fascia assembly. Refer to REAR WHEELHOUSE LINER PANEL REPLACEMENT .
1 Rear Bumper Lower Fascia Plastic Retainers (Qty: 4)
2 Rear Bumper Lower Fascia Bolts (Qty: 2)
CAUTION: Refer to FASTENER NOTICE .

Tightening torque 
6 N.m (53 lb in) 
Tip:  Remove the plastic covers to access the bolts.
3 Rear Bumper Lower Fascia
Tips 
  • Each side of the rear bumper upper fascia is secured to the quarter panel with two plastic retainers and an integral clip. For an image of these pieces refer to REAR BUMPER BRACKET REPLACEMENT .
  • Do not jerk on the rear fascia to remove or you may break the retainers on the rear fascia brackets.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.