SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUZUKI2013SX4 CROSSOVER, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 46 (BODY STRUCTURE)REPAIR INSTRUCTIONSFRONT BUMPER FASCIA SUPPORT REPLACEMENT
2013 Suzuki SX4 Crossover, Automatic CVT Trans

Front Bumper Fascia Support Replacement

2013 Suzuki SX4 Crossover, Automatic CVT TransSECTION Front Bumper Fascia Support Replacement
WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Front Bumper Fascia Support Components
G04843071Courtesy of SUZUKI OF AMERICA CORP.
FRONT BUMPER FASCIA SUPPORT COMPONENTS REFERENCE

Callout Component Name
Preliminary Procedures 
  1. Remove the hood overslam bumpers. Refer to HOOD BUMPER REPLACEMENT .
  2. Remove the primary hood latch. Refer to HOOD PRIMARY LATCH REPLACEMENT .
  3. Remove the front headlamps. Refer to HEADLAMP REPLACEMENT .
1 Front Bumper Fascia Support Bolt (Qty: 13)
CAUTION: Refer to FASTENER NOTICE .

Tightening torque 
10 N.m (89 lb in) 
2 Front Bumper Fascia Support
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.