SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUZUKI2013SX4 CROSSOVER, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 43 (ENGINE LUBRICATION SYSTEM)REPAIR INSTRUCTIONSOIL PAN ASSEMBLE
2013 Suzuki SX4 Crossover, Automatic CVT Trans

Oil Pan Assemble

2013 Suzuki SX4 Crossover, Automatic CVT TransSECTION Oil Pan Assemble
WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.

Reference: OIL PAN CLEANING AND INSPECTION 

Reference: OIL PUMP PIPE AND SCREEN CLEANING AND INSPECTION 

Fig 1: Identifying New Oil Suction Tube Seal
G04842557Courtesy of SUZUKI OF AMERICA CORP.
  1. Install a NEW oil suction tube seal onto the oil suction tube. DO NOT reuse the old oil suction tube seal.
    Fig 2: Identifying Oil Suction Pipe With Bolts
    G04842558Courtesy of SUZUKI OF AMERICA CORP.
  2. Install the oil suction pipe.
    CAUTION: Refer to FASTENER NOTICE .
  3. Install the oil suction pipe bolts.

    Tightening torque 

    Tighten the oil suction pipe bolts to 10 N.m (89 lb in)  .

    Fig 3: Identifying Oil Pan Scraper With Bolts
    G04842559Courtesy of SUZUKI OF AMERICA CORP.
  4. Install the oil pan scraper.
  5. Install the oil pan scraper bolts.

    Tightening torque 

    Tighten the oil pan scraper bolts to 10 N.m (89 lb in)  .

    Fig 4: Identifying Oil Pan Drain Plug
    G04842560Courtesy of SUZUKI OF AMERICA CORP.
  6. Install the oil pan drain plug and NEW O-ring seal.

    Tightening torque 

    Tighten the oil pan drain plug to 20 N.m (15 lb ft)  .

Reference: OIL PAN INSTALLATION 

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.