Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSSUZUKI2013SX4 CROSSOVER, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 41 (FUEL SYSTEM)REPAIR INSTRUCTIONSFILLER TUBE REPLACEMENTINSTALLATION PROCEDURE

2013 Suzuki SX4 Crossover, Automatic CVT Trans

Installation Procedure

2013 Suzuki SX4 Crossover, Automatic CVT TransSECTION Installation Procedure

WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Fuel Tank Fill Vent Hose (2 Of 2)

Courtesy of SUZUKI OF AMERICA CORP.

Attach the fuel tank fill vent hose to the fuel fill tube.

Fig 2: Installing Closeout Grommet
Courtesy of SUZUKI OF AMERICA CORP.
Install the closeout grommet.

Fig 3: Identifying Fuel Fill Tube
Courtesy of SUZUKI OF AMERICA CORP.
Position the fuel fill tube (1) to the vehicle.

Fig 4: Identifying Closeout Grommet & Fuel Fill Tube Bracket Bolts
Courtesy of SUZUKI OF AMERICA CORP.
Position the fuel fill tube to the closeout grommet (1).
CAUTION:
Refer to FASTENER NOTICE .
Install the fuel fill tube bracket bolts (2).
Tightening torque

Tighten the bolt to 12 N.m (106 lb in).

Fig 5: Identifying Fill Tube-To-Fuel Tank Connecting Hose
Courtesy of SUZUKI OF AMERICA CORP.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.