SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUZUKI2013SX4 CROSSOVER, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 4 (WIRING SYSTEMS)REPAIR INSTRUCTIONRELAY REPLACEMENT (WITHIN AN ELECTRICAL CENTER)REMOVAL PROCEDURE
2013 Suzuki SX4 Crossover, Automatic CVT Trans

Removal Procedure

2013 Suzuki SX4 Crossover, Automatic CVT TransSECTION Removal Procedure
WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the electrical center cover.
  2. Locate the relay. Refer to ELECTRICAL CENTER IDENTIFICATION VIEWS  to locate the electrical center where the relay exists.
    NOTE:
    • Always note the orientation of the relay.
    • Ensure that the electrical center is secure, as not to put added stress on the wires or terminals.
      Fig 1: Pulling Relay From Electrical Center
      G04844958Courtesy of SUZUKI OF AMERICA CORP.
  3. Using the J 43244 (1) position the tool on opposing corners of the relay (2).
    CAUTION: Use J43244 to pull the relay straight out from the electrical center terminals. The use of pliers or a flat bladed tool could damage the electrical center.
  4. Remove the relay (2) from the electrical center.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.