SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUZUKI2013SX4 CROSSOVER, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 38 (FRONT SUSPENSION)REPAIR INSTRUCTIONSSTABILIZER SHAFT INSULATOR REPLACEMENT
2013 Suzuki SX4 Crossover, Automatic CVT Trans

Stabilizer Shaft Insulator Replacement

2013 Suzuki SX4 Crossover, Automatic CVT TransSECTION Stabilizer Shaft Insulator Replacement
WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Stabilizer Shaft Insulator Components
G04842717Courtesy of SUZUKI OF AMERICA CORP.
PRELIMINARY PROCEDURES REFERENCE

Callout Component Name
Preliminary Procedures 
  1. Raise the vehicle. Refer to LIFTING AND JACKING THE VEHICLE .
  2. Remove the front wheel and tire assemblies. Refer to REMOVAL PROCEDURE .
1 Stabilizer Shaft Insulator Bolt (Qty: 2)
CAUTION: Refer to FASTENER NOTICE .

Tightening torque 
50 N.m (37 lb ft)  .
2 Stabilizer Shaft Insulator Clamp (Qty: 2)
3 Stabilizer Shaft Insulator (Qty: 2)
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.