Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUZUKI2013SX4 CROSSOVER, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 36 (TRANSFER)REPAIR INSTRUCTIONSTRANSFER CASE DISASSEMBLEINTERMEDIATE DRIVE SHAFT DISASSEMBLY
2013 Suzuki SX4 Crossover, Automatic CVT Trans
Intermediate Drive Shaft Disassembly
2013 Suzuki SX4 Crossover, Automatic CVT TransSECTION Intermediate Drive Shaft Disassembly
WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.
CALLOUT AND COMPONENT NAME TABLE
| Callout | Component Name |
|---|---|
| 1 | Half Shaft Retainer |
| 2 | O-Ring |
| 3 | Front Wheel Drive Intermediate Shaft Bearing Retainers (Qty: 2) |
| 4 | Front Wheel Drive Intermediate Shaft Bearing Assembly Tip: Use a press, with the J 22912-B flat side up, in order to remove the bearing assembly. Special Tools J 22912-B Rear Pinion and Axle Bearing Remover |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.