Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUZUKI2013SX4 CROSSOVER, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 36 (TRANSFER)REPAIR INSTRUCTIONSFRONT DRIVE AXLE INNER SHAFT SEAL REPLACEMENT
2013 Suzuki SX4 Crossover, Automatic CVT Trans
Front Drive Axle Inner Shaft Seal Replacement
2013 Suzuki SX4 Crossover, Automatic CVT TransSECTION Front Drive Axle Inner Shaft Seal Replacement
WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.
CALLOUT AND COMPONENT NAME TABLE
| Callout | Component Name |
|---|---|
| 1 | Front Drive Axle Intermediate Shaft Seal Assembly Tip: DT-48078 seats the seal to a specific depth. Other installation methods may set the seal to a non-functional depth. Special Tools
|
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.