Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSSUZUKI2013SX4 CROSSOVER, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 30 (ENGINE MECHANICAL)REPAIR INSTRUCTIONSENGINE FRONT COVER REMOVAL (FOURTH DESIGN)

2013 Suzuki SX4 Crossover, Automatic CVT Trans

Engine Front Cover Removal (Fourth Design)

2013 Suzuki SX4 Crossover, Automatic CVT TransSECTION Engine Front Cover Removal (Fourth Design)

WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.

Reference: WATER PUMP REMOVAL .

Special Tool

EN 46105 Camshaft Locking Tool

EN 46111 Crankshaft Rotation Socket

Fig 1: Identifying Camshaft Position Sensor & Bolts

Courtesy of SUZUKI OF AMERICA CORP.

Remove the camshaft position sensor bolts.
Remove the camshaft position sensors.

Fig 2: Identifying Camshaft Position Actuator Valve & Bolts
Courtesy of SUZUKI OF AMERICA CORP.
Remove the camshaft position actuator valve bolts.
Remove the camshaft position actuator valves from the front cover.

Fig 3: Identifying Engine Front Cover Bolts
Courtesy of SUZUKI OF AMERICA CORP.
Remove the engine front cover bolts that hold the engine front cover deadener into position.

Fig 4: Identifying Engine Front Cover Deadener
Courtesy of SUZUKI OF AMERICA CORP.
Remove the engine front cover deadener.

Fig 5: Identifying Engine Front Cover Bolts
Courtesy of SUZUKI OF AMERICA CORP.
Remove the remaining engine front cover bolts.

Fig 6: Identifying Jackscrew Hole
Courtesy of SUZUKI OF AMERICA CORP.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.