Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSSUZUKI2013SX4 CROSSOVER, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 30 (ENGINE MECHANICAL)REPAIR INSTRUCTIONSCYLINDER HEAD REPLACEMENT - LEFT SIDEINSTALLATION PROCEDURE

2013 Suzuki SX4 Crossover, Automatic CVT Trans

Installation Procedure

2013 Suzuki SX4 Crossover, Automatic CVT TransSECTION Installation Procedure

WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.

If necessary, perform the following steps:
- Assemble the cylinder head. Refer to CYLINDER HEAD ASSEMBLE .
- Install the camshaft. Refer to CAMSHAFT INSTALLATION - LEFT SIDE .
- Install the exhaust manifold to the cylinder head. Refer to EXHAUST MANIFOLD INSTALLATION - LEFT SIDE .
  
  Fig 1: Identifying Cylinder Head Gasket
  Courtesy of SUZUKI OF AMERICA CORP.
Install a NEW cylinder head gasket.

Fig 2: Identifying Cylinder Head
Courtesy of SUZUKI OF AMERICA CORP.
Carefully install the cylinder head with the exhaust manifold to the engine. Refer to CYLINDER HEAD INSTALLATION - LEFT SIDE .
Install the catalytic converter to the exhaust manifold. Refer to INSTALLATION PROCEDURE .
Connect the wiring harness electrical connector located at the side of the cylinder head.

Fig 3: Identifying Wiring Harness Ground
Courtesy of SUZUKI OF AMERICA CORP.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.