SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUZUKI2013SX4 CROSSOVER, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 30 (ENGINE MECHANICAL)REPAIR INSTRUCTIONSAIR CLEANER ASSEMBLY REPLACEMENTINSTALLATION PROCEDURE
2013 Suzuki SX4 Crossover, Automatic CVT Trans

Installation Procedure

2013 Suzuki SX4 Crossover, Automatic CVT TransSECTION Installation Procedure
WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Air Cleaner Assembly (2 Of 2)
G04841406Courtesy of SUZUKI OF AMERICA CORP.
  1. If the air cleaner assembly was replaced, install the MAF/IAT sensor. Refer to INSTALLATION PROCEDURE .
  2. Install the air cleaner assembly by inserting the two pins into the front panel.
    CAUTION: Refer to FASTENER NOTICE .
  3. Install the air cleaner bolt.

    Tightening torque 

    Tighten the bolt to 10 N.m (89 lb in)  .

    Fig 2: Connecting Engine Wiring Harness Electrical Connector
    G04841407Courtesy of SUZUKI OF AMERICA CORP.
  4. Connect the engine wiring harness electrical connector to the MAF/IAT sensor.
  5. Install the air cleaner outlet duct. Refer to INSTALLATION PROCEDURE .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.