Differential Carrier Assembly Mount Replacement

2013 Suzuki SX4 Crossover, Automatic CVT TransSECTION Differential Carrier Assembly Mount Replacement
WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Differential Mount, Nut, And Bolts
G04843788Courtesy of SUZUKI OF AMERICA CORP.
PROCEDURE TABLE

Callout Component Name
Preliminary Procedure 
Raise the vehicle. Refer to LIFTING AND JACKING THE VEHICLE .
1 Left Rear Differential Mount Nut
CAUTION: Refer to FASTENER NOTICE .

Tip:  Support the rear differential with a jack stand.
Tightening torque 
Tighten the nut to 121 N.m (89 lb ft). 
2 Left Rear Differential Mount Bolt (Qty: 2)
Tightening torque 
Tighten the nut to 29 N.m (21 lb ft). 
3 Left Rear Differential Mount Bolt (Qty: 2)
Tightening torque 
Tighten the nut to 29 N.m (21 lb ft). 
4 Left Rear Differential Mount
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.