Rear Wheel Speed Sensor Replacement

2013 Suzuki SX4 Crossover, Automatic CVT TransSECTION Rear Wheel Speed Sensor Replacement
WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Rear Wheel Speed Sensor Components
G04843978Courtesy of SUZUKI OF AMERICA CORP.
BRAKE SYSTEM SCHEMATICS TABLE

Callout Component Name
WARNING: Refer to BRAKE DUST CAUTION .
Preliminary Procedures 
  1. Raise and support the vehicle. Refer to LIFTING AND JACKING THE VEHICLE .
  2. Remove the tire and wheel. Refer to REMOVAL PROCEDURE .
  3. Remove the park brake shoes. Refer to PARK BRAKE SHOE REPLACEMENT .
1 Wheel Speed Sensor Electrical Connector
2 Wheel Speed Sensor Bolt
CAUTION: Refer to FASTENER NOTICE .

Tightening torque 
8 N.m (71 lb in) 
3 Wheel Speed Sensor
Procedure 
  1. Release the wheel speed sensor electrical harness grommet from the backing plate.
  2. Route the wheel speed sensor electrical harness through the backing plate.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.