Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUZUKI2013SX4 CROSSOVER, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 19 (BRAKES - ABS)DIAGNOSTIC INFORMATION AND PROCEDURESDTC TABLE
2013 Suzuki SX4 Crossover, Automatic CVT Trans
DTC Table
2013 Suzuki SX4 Crossover, Automatic CVT TransSECTION DTC Table
WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.
DIAGNOSTIC TROUBLE CODES (DTC) LIST
| DTC | Description |
|---|---|
| C0035 | Left Front Wheel Speed Sensor Circuit |
| C0040 | Right Front Wheel Speed Sensor Circuit |
| C0045 | Left Rear Wheel Speed Sensor Circuit |
| C0050 | Right Rear Wheel Speed Sensor Circuit |
| C0110 | Pump Motor Circuit |
| C0131 | ABS Pressure Circuit |
| C0161 | Anti-lock Brake System (ABS) Brake Switch/Sensor Circuit not Plausible |
| C0186 | Lateral Accelerometer Circuit |
| C0196 | Yaw Rate Circuit |
| C0201 | Anti-lock Brake System (ABS) Enable Relay Contact Circuit |
| C0252 | Dynamic Sensor Offset Checksum Error |
| C0280 | Stability System Active Too Long |
| C0292 | VSES Combination Sensor Circuits |
| C0460 | Steering Position Signal |
| C0550 | Electronic Control Unit (ECU) Performance |
| C0551 | Option Configuration Error |
| C0561 | System Disabled Information Stored |
| C0899 | Device Voltage Low |
| C0900 | Device Voltage High |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.