Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUZUKI2013SX4 CROSSOVER, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 19 (BRAKES - ABS)DIAGNOSTIC INFORMATION AND PROCEDURESDTC C0460CIRCUIT/SYSTEM VERIFICATION
2013 Suzuki SX4 Crossover, Automatic CVT Trans
Circuit/System Verification
2013 Suzuki SX4 Crossover, Automatic CVT TransSECTION Circuit/System Verification
WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.
- Position the steering wheel to the straight-ahead, centered, position.
- Install a scan tool, ignition ON, engine OFF, and view steering wheel position, the signal should be approximately 0° with the steering wheel straight ahead and should varies approximately 720+ or 720-.
- As the steering wheel is turned, signal should travel smoothly between 720°+ 720°-.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.