Windshield Washer Hose Replacement

2013 Suzuki SX4 Crossover, Automatic CVT TransSECTION Windshield Washer Hose Replacement
WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Air Inlet Grille Panel Assembly & Windshield Washer Hose Front
G04845200Courtesy of SUZUKI OF AMERICA CORP.
WINDSHIELD WASHER HOSE TABLE

Callout Component Name
CAUTION: Refer to FASTENER NOTICE .
Fastener Tightening Specifications: Refer to Β FASTENER TIGHTENING SPECIFICATIONS - WIPERS/WASHER SYSTEMSΒ Β .Β 
1 Air Inlet Grille Panel Assembly
Refer to AIR INLET GRILLE PANEL REPLACEMENT .
2 Windshield Washer Hose Front
Tip:Β  Separate the front washer nozzle hose from the front washer solvent container hose that runs along the upper motor compartment rail.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.