Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Rear Washer Hose Routing
The rear washer hose is a component of the main body wire harness assembly. The rear washer hose is a hard plastic convoluted tube that is wrapped in the electrical tape along with the main body wiring harness. It starts underhood where it connects to the rear washer solvent container hose, this is rubber tubing. The rear washer hose routes into the main body wire harness underhood and passes through the front of the dash. The rear washer hose runs inside the vehicle interior along the left side rocker and over the right side at the 2nd bar beneath the front seats. It proceeds over the right side wheel housing and up the right side pillar where it connects to the washer nozzle hose, at the top of the lift gate opening.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.