Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUZUKI2013SX4 CROSSOVER, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 18 (WIPERS/WASHERS)DIAGNOSTIC INFORMATION AND PROCEDURESWASHER MALFUNCTION (FRONT)COMPONENT TESTING
2013 Suzuki SX4 Crossover, Automatic CVT Trans
Component Testing
2013 Suzuki SX4 Crossover, Automatic CVT TransSECTION Component Testing
WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.
Windshield Wiper Washer Switch
- With the WASH switch in the open position, test for infinite resistance between the ground terminal D and the signal terminal B.
- If not the specified value, replace the windshield wiper washer switch.
- With the WASH switch in the closed position, test for less than 2 ohms of resistance between the ground terminal D and the signal terminal B.
- If greater than the specified range, replace the windshield wiper washer switch.
Washer Pump
- Ignition OFF, disconnect the harness connector at the washer pump.
- Install a 10A fused jumper wire between the control terminal 2 and 12 volts. Install a jumper wire between the ground terminal 1 and ground.
- Verify the washer pump is activated.
- If the washer pump does not activate, replace the washer pump.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.