Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUZUKI2013SX4 CROSSOVER, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 17 (SECURITY AND LOCKS)REPAIR INSTRUCTIONSFRONT SIDE DOOR LOCK STRIKER REPLACEMENT
2013 Suzuki SX4 Crossover, Automatic CVT Trans
Front Side Door Lock Striker Replacement
2013 Suzuki SX4 Crossover, Automatic CVT TransSECTION Front Side Door Lock Striker Replacement
WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.
FRONT SIDE DOOR LOCK STRIKER REPLACEMENT REFERENCE
| Callout | Component Name |
|---|---|
|
WARNING:
In order to prevent SIR deployment, personal injury, or unnecessary SIR system repairs, do not strike the door or the door pillar in the area of the side impact sensor (SIS). Turn OFF the ignition and remove the key when performing service in the area of the SIS.
|
|
| 1 | Front Side Door Lock Striker Bolt (Qty: 2)
CAUTION:
Refer to FASTENER NOTICE
. Tightening torque 25 N.m (18 lb ft) |
| 2 | Front Side Door Lock Striker Assembly Tip: Ensure proper alignment after installation. Refer to FRONT SIDE DOOR LOCK STRIKER ADJUSTMENT . |
| 3 | Front Side Door Lock Striker Spacer |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.