Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSSUZUKI2013SX4 CROSSOVER, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 17 (SECURITY AND LOCKS)REPAIR INSTRUCTIONSFRONT SIDE DOOR LATCH REPLACEMENTREMOVAL PROCEDURE

2013 Suzuki SX4 Crossover, Automatic CVT Trans

Removal Procedure

2013 Suzuki SX4 Crossover, Automatic CVT TransSECTION Removal Procedure

WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Front Side Door Latch And Front Door Window Regulator Module

Courtesy of SUZUKI OF AMERICA CORP.

Remove the front door window regulator module. Refer to REMOVAL PROCEDURE .
Disconnect the outside handle rod from the latch.

Fig 2: Front Side Door Latch (2 Of 2)
Courtesy of SUZUKI OF AMERICA CORP.
Remove the outside handle bracket.
Disconnect the lock cylinder rod from the latch.
Disconnect the latch electrical connector.

Fig 3: Latch Electrical Connector
Courtesy of SUZUKI OF AMERICA CORP.
Disconnect the latch arm from the window regulator module by depressing the tab and sliding rearward.
Disconnect the inside handle rod and lock button rod by twisting the latch.

Fig 4: Inside Handle Rod & Lock Button Rod (1 Of 2)
Courtesy of SUZUKI OF AMERICA CORP.
Remove the latch from the latch arm by twisting.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.