Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DBβ LIVE
HOMESERVICE MANUALSSUZUKI2013SX4 CROSSOVER, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 17 (SECURITY AND LOCKS)DIAGNOSTIC INFORMATION AND PROCEDURESDTC B3265CIRCUIT / SYSTEM TESTING
2013 Suzuki SX4 Crossover, Automatic CVT Trans
Circuit / System Testing
2013 Suzuki SX4 Crossover, Automatic CVT TransSECTION Circuit / System Testing
WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition OFF, disconnect the harness connector at the liftgate switch.
- Ignition OFF, test for less than 1.0 Ξ© of resistance between the ground circuit terminal C and ground.
- If greater than the specified range, test the ground circuit for an open / high resistance.
- Ignition ON, verify the scan tool Ext Trunk / Liftglass Rel Sw parameter is Inactive.
- If not the specified value, test the signal circuit terminal A for a short to ground. If the circuit tests normal, replace the BCM.
- Install a 3-A fused jumper wire between the signal circuit terminal A and ground. Verify the scan tool Ext Trunk / Liftglass Rel Sw parameter is Active.
- If not the specified value, test the signal circuit for a short to voltage or an open / high resistance. If the circuit tests normal, replace the BCM.
- If all circuits test normal, test or replace the liftgate switch.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.