Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUZUKI2013SX4 CROSSOVER, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 15 (INSTRUMENTATION/DRIVER INFO./HORN)DIAGNOSTIC INFORMATION AND PROCEDURESFOG LAMP INDICATOR INOPERATIVECOMPONENT TESTING
2013 Suzuki SX4 Crossover, Automatic CVT Trans
Component Testing
2013 Suzuki SX4 Crossover, Automatic CVT TransSECTION Component Testing
WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition OFF, disconnect the harness connector at the fog lamp switch.
- Test for infinite resistance between the signal terminal and the voltage supply terminal with the switch in the open position.
- If less than infinite resistance, replace the fog lamp switch.
- Test for less than 2 ohms between the signal terminal and the voltage supply terminal with the switch in the closed position.
- If greater than 2.1 ohms, replace the fog lamp switch.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.