Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DBβ LIVE
HOMESERVICE MANUALSSUZUKI2013SX4 CROSSOVER, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 15 (INSTRUMENTATION/DRIVER INFO./HORN)DIAGNOSTIC INFORMATION AND PROCEDURESDTC B2965CIRCUIT/SYSTEM TESTING
2013 Suzuki SX4 Crossover, Automatic CVT Trans
Circuit/System Testing
2013 Suzuki SX4 Crossover, Automatic CVT TransSECTION Circuit/System Testing
WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition OFF, disconnect the harness connector at the ignition switch.
- Ignition OFF, test for less than 1 Ξ© of resistance between the ground circuit and ground.
- If greater than 1 Ξ© test the ground circuit for an open/high resistance.
- Ignition ON, install a 3-amp fused jumper between the signal circuit and ground. Verify the scan tool Key In Ignition parameter displays Yes.
- If not Yes, test the signal circuit for an open/high resistance. If the circuit tests normal, replace the BCM.
- Ignition ON, engine OFF, verify the Ignition 1 Input parameter displays Off.
- If not Off, test the ignition 1 voltage circuit for a short to voltage.
- If all circuits test normal, test or replace the ignition switch.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.