Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUZUKI2013SX4 CROSSOVER, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 14 (AUTOMATIC TRANSMISSION)SCHEMATIC AND ROUTING DIAGRAMAUTOMATIC TRANSMISSION RELATED CONNECTOR END VIEWSSTOP LAMP SWITCH - LOWER
2013 Suzuki SX4 Crossover, Automatic CVT Trans
Stop Lamp Switch - Lower
2013 Suzuki SX4 Crossover, Automatic CVT TransSECTION Stop Lamp Switch - Lower
WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.
Connector Part Information
OEM: 1204143
Service:
Description: 2-Way F Metri-Pack 280 Series (BK)
Terminal Part Information
Terminal:
Core/Insulation Crimp:
Release Tool/Test Probe:
CONNECTORS FUNCTION TABLE - STOP LAMP SWITCH (LOWER)
| Pin | Wire Color | Circuit No. | Function |
|---|---|---|---|
| A | PK | 339 | Ignition 1 Voltage |
| B | VT | 420 | TCC Brake Switch/Cruise Control Release Signal |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.