SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUZUKI2013SX4 CROSSOVER, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 14 (AUTOMATIC TRANSMISSION)REPAIR INSTRUCTIONSAUTOMATIC TRANSMISSION WIRING HARNESS REPLACEMENTINSTALLATION PROCEDURE
2013 Suzuki SX4 Crossover, Automatic CVT Trans

Installation Procedure

2013 Suzuki SX4 Crossover, Automatic CVT TransSECTION Installation Procedure
WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Transmission Wiring Harness Assembly, TCM Seal & Wiring Connector Seal
G04845965Courtesy of SUZUKI OF AMERICA CORP.
  1. Apply GM T-IV automatic transaxle fluid GM P/N 88900925 to a NEW transaxle wiring connector O-ring seal (46).
  2. Install the NEW automatic transmission wiring connector seal (46) in the bore for the connector. The taper side of the seal goes up.
  3. Install a NEW TCM seal (72) on the connector.
  4. Install the transmission wiring harness assembly (33) into the transmission case assembly through the wiring harness bore.
    Fig 2: Identifying Wiring Harness Connector Retainer
    G04845966Courtesy of SUZUKI OF AMERICA CORP.
  5. Align the tab of the connector in the transmission case.
  6. Install the wiring harness connector retainer (69).
    Fig 3: Identifying Transaxle Fluid Temperature Sensor & Sensor Clip
    G04845967Courtesy of SUZUKI OF AMERICA CORP.
  7. Apply GM T-IV automatic transaxle fluid GM P/N 88900925 to a new transaxle fluid temperature sensor O-ring seal (32).
  8. Install a new transaxle fluid temperature sensor O-ring seal (32) into the groove of the transaxle fluid temperature sensor (36).
  9. Install the transaxle fluid temperature sensor (36) into the front control valve body fluid temperature sensor bore.
  10. Install the transaxle fluid temperature sensor clip (49).
  11. Install the fluid temperature sensor bolt (31).

    Tightening torque 

    Tighten the bolt to 10 N.m (89 lb in)  .

    Fig 4: Identifying Solenoid Wire Connectors
    G04845968Courtesy of SUZUKI OF AMERICA CORP.
  12. Connect the 8 solenoid wire connectors as follows:
    • 1 blue
    • 2 black
    • 3 green
    • 4 black
    • 5 blue
    • 6 gray
    • 7 brown
    • 8 black
  13. Install the control valve body cover. Refer to INSTALLATION PROCEDURE .
  14. Perform the transmission adaptive learn procedure. Refer to TRANSMISSION ADAPTIVE LEARN AND TRANSMISSION NEUTRAL LEARN .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.