SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUZUKI2013SX4 CROSSOVER, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 14 (AUTOMATIC TRANSMISSION)DIAGNOSTIC INFORMATION AND PROCEDURENO. 3-2 DOWNSHIFT
2013 Suzuki SX4 Crossover, Automatic CVT Trans

No. 3-2 Downshift

2013 Suzuki SX4 Crossover, Automatic CVT TransSECTION No. 3-2 Downshift
WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.
DIAGNOSTIC TABLE - NO 3-2 DOWNSHIFT

Checks Actions
DEFINITION: No third gear to second gear downshift
External Automatic Transmission Control Valve Body Assembly (39)
  • 2-3, 3-4 Shift Solenoid Valve Assembly (S2) (308)
  • 1-2, 2-3, Reverse Shift Solenoid Valve Assembly (S3) (300)
  • 3-4, 4-5 Shift Solenoid Valve Assembly (S4) (303)
  • Line Pressure Control Solenoid Valve Assembly (SLT) (316)
 Verify that all solenoids respond electrically. If there is no response, perform an electrical diagnosis. If there are no electrical concerns, remove the solenoid valve assemblies as needed, and inspect the solenoid O-ring seals, and the solenoid bores for signs of damage and/or missing seals. If the solenoid valves responded electrically and there are no bore or seal concerns, replace the solenoid valve assemblies as necessary due to possible internal mechanical concerns and retest. If a condition is still present after replacing the solenoid valve assembly, replace the complete automatic transmission control valve body assembly (39).
Internal Automatic Transmission Control Valve Body Assembly (39)
  • M1 Shift Valve (389)
  • M2 Shift Valve (426)
  • U1 Shift Valve (386)
  • U2 Shift Valve (392)
 Remove the automatic transmission control valve body assembly (39) and inspect the items listed. Inspect the internal bores and the valves for signs of wear and/or damage, including internal contamination. If unable to verify any repairable concerns, replace the complete automatic transmission control valve body assembly (39).
Clutch - Mechanical/Hydraulic
1-2 Reverse Clutch Assembly (19) Remove the automatic transmission case cover and 1-2 reverse clutch assembly (19). Inspect all 1-2 reverse clutch components for proper operation. Repair or replace as necessary.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.