Dome Lamp Replacement (Without DVD)

2013 Suzuki SX4 Crossover, Automatic CVT TransSECTION Dome Lamp Replacement (Without DVD)
WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Dome Lamp Assembly & Lens (Without DVD)
G04845089Courtesy of SUZUKI OF AMERICA CORP.
DOME LAMP REPLACEMENT REFERENCE (WITHOUT DVD)

Callout Component Name
CAUTION: Refer to FASTENER NOTICE .
Fastener Tightening Specifications: Refer to Β FASTENER TIGHTENING SPECIFICATIONS - LIGHTINGΒ Β .Β 
1 Dome Lamp Lens
Tip:Β  Use a small flat bladed tool to aid in the removal of the lens.
2 Dome Lamp Assembly
  1. Using a small flat-bladed tool, disengage the dome lamp attaching clips by gently prying at each side of the retaining tab while pulling the tab off of the headliner.
  2. Pull the forward edge of the dome lamp downward and rearward to disengage the lamp from the headliner.
  3. Disconnect the electrical connector.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.