Daytime Running Lamps (DRL) Resistor Replacement

2013 Suzuki SX4 Crossover, Automatic CVT TransSECTION Daytime Running Lamps (DRL) Resistor Replacement
WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Forward Lamp Wiring Harness Assembly, Daytime Running Lamp Resistor Assembly & Bolt
G04845086Courtesy of SUZUKI OF AMERICA CORP.
DAYTIME RUNNING LAMPS (DRL) RESISTOR REPLACEMENT REFERENCE

Callout Component Name
Preliminary Procedures 
Remove the front bumper fascia. Refer to FRONT BUMPER FASCIA REPLACEMENT .
1 Forward Lamp Wiring Harness Assembly
2 Daytime Running Lamp Resistor Assembly Bolt
CAUTION: Refer to FASTENER NOTICE .

Tightening torque 
10 N.m (89 lb in) 
3 Daytime Running Lamp Resistor Assembly
Procedure 
Disconnect the electrical connector.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • You smell fuel, burning insulation, or see smoke.
  • Brakes feel soft, pull hard to one side, or make grinding noises.
  • The engine overheats, stalls repeatedly, or misfires under load.
  • You are missing required tools, torque specs, or safe lifting equipment.
  • You are not confident in the next step or safety outcome.