Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUZUKI2013SX4 CROSSOVER, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 13 (LIGHTING SYSTEMS)DIAGNOSTIC INFORMATION AND PROCEDURESSCAN TOOL DATA LIST - LIGHTING
2013 Suzuki SX4 Crossover, Automatic CVT Trans
Scan Tool Data List - Lighting
2013 Suzuki SX4 Crossover, Automatic CVT TransSECTION Scan Tool Data List - Lighting
WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.
EXTERIOR LAMPS REFERENCE
| Scan Tool Parameter | Units Displayed | Typical Data Value |
|---|---|---|
| Ignition On, Engine Off | ||
| Ambient Light Sensor | Volts | 0.4-4 volts |
| Battery 1 | Volts | Battery Voltage |
| DRL Relay Command | On/Off | On when requested |
| DRL Relay Feedback | High/Low | Low when requested |
| Fog Lamp Relay Cmd. | On/Off | On when requested |
| Fog Lamp Relay Fdbk. | High/Low | Low when requested |
| Fog Lamp Switch | On/Off | On when requested |
| High Beam Switch | On/Off | On when requested |
| Low Beam Input | Volts | 0.4 volts - Battery Voltage |
| Low Beam Input = Off | Yes/No | Yes when Low Beams requested |
| Low Beam Input = DRL | Yes/No | Yes when DRL requested |
| Low Beam Input = High | Yes/No | No when Low Beams requested |
| Parklamp Switch | On/Off | On when Park Lamps requested |
INTERIOR LAMPS REFERENCE
| Scan Tool Parameter | Units Displayed | Typical Data Value |
|---|---|---|
| Ignition On, Engine Off | ||
| Battery 1 | Volts | Battery Voltage |
| Dome Lamp Command | On/Off | On when Dome requested |
| Dome Lamp Feedback | High/Low | Low when Dome requested |
| Driver Door Switch | High/Low | Low with Driver Door Open |
| Inadvertent Power Cmd. | On/Off | On |
| Inadvertent Power Fdbk. | High/Low | High when On |
| Key In Ignition | Yes/No | Yes |
| Pass Door Switches | High/Low | Low with any Door Open |
SWITCH INPUTS REFERENCE
| Scan Tool Parameter | Units Displayed | Typical Data Value |
|---|---|---|
| Ignition On, Engine Off | ||
| Liftgate Ajar Switch | High/Low | Low with Liftgate Open |
| Park Brake Switch | On/Off | Off |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.