Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUZUKI2013SX4 CROSSOVER, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 13 (LIGHTING SYSTEMS)DIAGNOSTIC INFORMATION AND PROCEDURESSCAN TOOL DATA DEFINITIONS - LIGHTINGBCM OUTPUTS
2013 Suzuki SX4 Crossover, Automatic CVT Trans
BCM Outputs
2013 Suzuki SX4 Crossover, Automatic CVT TransSECTION BCM Outputs
WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.
BCM OUTPUTS REFERENCE
| Backup Lamps | The scan tool displays ON/OFF. This output of the BCM is displayed as ON when the backup lamps are turned ON. |
| Brake Applied Outputs | The scan tool displays ON/OFF. This output of the BCM is displayed as ON when the brake pedal is applied. |
| Front Fog Lamp Relay | The scan tool displays ON/OFF. This output of the BCM is displayed as ON when the fog lamps are turned ON. |
| Instrumentation Backlight | The scan tool displays ON/OFF. This output of the BCM is displayed as ON when the I/P lamps are commanded ON by the BCM. |
| Interior Lamp Output | The scan tool displays ON/OFF. This output of the BCM is displayed as ON when the interior lamps are turned ON. |
| LF Turn/DRL Lamp Status | The scan tool displays ON/OFF. This output of the BCM is displayed as ON when the left turn signal is turned ON or when the BCM turns ON the DRL lamps. |
| LR Stop/Turn Signal Lamp | The scan tool displays ON/OFF. This output of the BCM is displayed as ON when the left turn signal is turned ON or when the brakes are applied. |
| Low Beam Relay Command | The scan tool displays ON/OFF. This output of the BCM is displayed as ON when the low beam headlamps are turned ON. |
| Park Lamp Relay | The scan tool displays ON/OFF. This output of the BCM is displayed as ON when the park lamps are turned ON. |
| RF Turn/DRL lamp Status | The scan tool displays ON/OFF. This output of the BCM is displayed as ON when the right turn signal is turned ON or when the BCM turns ON the DRL lamps. |
| RR Stop/Turn Signal Lamp | The scan tool displays ON/OFF. This output of the BCM is displayed as ON when the right turn signal is turned ON or when the brakes are applied. |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.