SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUZUKI2013SX4 CROSSOVER, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 13 (LIGHTING SYSTEMS)DIAGNOSTIC INFORMATION AND PROCEDURESREADING LAMP(S) INOPERATIVECOMPONENT TESTING
2013 Suzuki SX4 Crossover, Automatic CVT Trans

Component Testing

2013 Suzuki SX4 Crossover, Automatic CVT TransSECTION Component Testing
WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.

Reading Lamp Assembly Testing 

  1. Ignition OFF, disconnect the harness connector at the reading lamp assembly.
  2. Test for less than 2.0 ohms between the signal terminal and the ON terminal with the switch in the ON position.
    • If greater than 2.0 ohms, replace the reading lamp assembly.

Reading Lamp, Light Bulb Testing 

  1. Ignition OFF, remove the reading lamp bulb.
  2. Test for 1.0 to 4.5 ohms of resistance between the control terminal and the voltage supply terminal of the reading lamp bulb.
    • If the resistance is not within the specified range, replace the reading lamp bulb.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.