Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Circuit/System Description
The body control module (BCM) applies a ground through the brake pedal position sensor low reference circuit to the brake pedal position sensor (BPP). The BCM supplies a 5-volt reference through the brake sensor reference voltage circuit to the BPP. When the brake pedal is being applied, the BPP then sends a variable voltage through the brake sensor signal circuit to the BCM. The BCM then applies a signal to the brake signal circuit to the engine control module (ECM) and transmission control module (TCM).
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.