Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUZUKI2013SX4 CROSSOVER, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 13 (LIGHTING SYSTEMS)DIAGNOSTIC INFORMATION AND PROCEDURESDTC B2530CIRCUIT/SYSTEM TESTING
2013 Suzuki SX4 Crossover, Automatic CVT Trans
Circuit/System Testing
2013 Suzuki SX4 Crossover, Automatic CVT TransSECTION Circuit/System Testing
WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.
- Clear the DTC. Park lamp switch OFF, fog lamp switch OFF. Disconnect the underhood fuseblock terminal C2 pin 19. Using a test lamp connected to ground, probe the fog lamp control circuit. Verify the test lamp illuminates.
- If the test lamp does not illuminate, replace the Underhood Fuseblock.
- Test for a short to voltage in the fog lamp control circuit, Underhood Fuseblock terminal C2 pin 19.
- If all circuits/connections test normal, replace the BCM.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.