Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUZUKI2013SX4 CROSSOVER, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 12 (POWER SEAT SYSTEM)REPAIR INSTRUCTIONSREAR SEAT REPLACEMENTINSTALLATION PROCEDURE
2013 Suzuki SX4 Crossover, Automatic CVT Trans
Installation Procedure
2013 Suzuki SX4 Crossover, Automatic CVT TransSECTION Installation Procedure
WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.
- Install the rear seat to the vehicle, locating the seat over the studs on the floor.
- Secure the rear of the seat by pushing down on the back of the seat ensuring that the seat latch (2) is securely latched.
- Install the 6 attachments nuts (1) to the front and side risers of the seat.
Tightening torque
Tighten the bolts to 40 N.m (30 lb ft) .
- Remove the bolt (1) after that seat is securely in place.
- Return the rear seat to its original position.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.