Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSSUZUKI2013SX4 CROSSOVER, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 12 (POWER SEAT SYSTEM)REPAIR INSTRUCTIONSFRONT SEAT ADJUSTER REPLACEMENT

2013 Suzuki SX4 Crossover, Automatic CVT Trans

Front Seat Adjuster Replacement

2013 Suzuki SX4 Crossover, Automatic CVT TransSECTION Front Seat Adjuster Replacement

WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Front Seat Adjuster Components

Courtesy of SUZUKI OF AMERICA CORP.

FRONT SEAT ADJUSTER COMPONENTS REFERENCE

Callout	Component Name
Preliminary Procedure Remove the front seat. Refer to FRONT SEAT REPLACEMENT - BUCKET . Remove the seat cushion cover and pad. Refer to FRONT SEAT CUSHION COVER AND PAD REPLACEMENT .
1	Front Seat Back Recliner Nut (Qty: 6) CAUTION: Refer to FASTENER NOTICE . Tightening torque 45 N.m (33 lb ft)
2	Front Seat Cushion Frame Bolt (Qty: 4) Tightening torque 12 N.m (9 lb ft)
3	Front Seat Cushion Frame
4	Front Seat Adjuster Assembly Procedure Use a flat-bladed tool to remove the recliner cable from the seat frame. When replacing the adjuster assembly with a new unit, transfer components as necessary.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.