Door Lock Operation Inspection (Keyless Start System)

2013 Suzuki SX4 Crossover, Automatic CVT TransSECTION Door Lock Operation Inspection (Keyless Start System)
WARNING: This page is about a different car, the 2011 Suzuki SX4. However, it is still accessible from the selected car via links, so may be relevant.
  1. Check that all door locks are released and all doors are closed.
  2. With remote controller of which ID code is registered in keyless start control module carried with yourself, check that pushing driver door request switch once locks all doors.
  3. Check that pushing request switch of driver door, passenger door or rear end door (Hatchback) once releases corresponding door lock.
  4. Check that pushing again request switch pushed in Step 3) releases all door locks.
    Fig 1: Identifying Driver Door Switch
    G06869294Courtesy of SUZUKI OF AMERICA CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.