SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUZUKI2013SX4 CROSSOVER, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 110 (KEYLESS START SYSTEM)DIAGNOSTIC INFORMATION AND PROCEDURESDTC CLEARANCE
2013 Suzuki SX4 Crossover, Automatic CVT Trans

DTC Clearance

2013 Suzuki SX4 Crossover, Automatic CVT TransSECTION DTC Clearance
WARNING: This page is about a different car, the 2011 Suzuki SX4. However, it is still accessible from the selected car via links, so may be relevant.
  1. Perform Steps 1) through 5) of DTC check procedure and have DTC indicated.
  2. Open driver side door.
  3. Close driver side door and within 10 seconds after that, perform Steps a) to c) described below.
    1. Push unlock side (3) of driver side manual door lock switch (1).
    2. Push lock side (2) of driver side manual door lock switch.
    3. Repeat Steps a) and b) 3 times.

      At the end of Step c), DTCs are cleared and key indicator light indicates DTC No. 12 (Normal).

      Fig 1: Identifying Lock And Unlock Side Of Driver Side Manual Door Lock Switch
      G06869292Courtesy of SUZUKI OF AMERICA CORP.
  4. After completing DTC clearance, remove ignition key from ignition key cylinder.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.