Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUZUKI2013SX4 CROSSOVER, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 11 (CHARGING SYSTEM)REPAIR INSTRUCTIONSBATTERY BOX REPLACEMENTINSTALLATION PROCEDURE
2013 Suzuki SX4 Crossover, Automatic CVT Trans
Installation Procedure
2013 Suzuki SX4 Crossover, Automatic CVT TransSECTION Installation Procedure
WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.
- Position the battery box on the battery tray.CAUTION: Refer to FASTENER NOTICE .
- Install the battery box mounting bolts.
Tightening torque
Tighten the bolts to 20 N.m (15 lb ft).
- Install the battery vent tube from the battery box.
- Install the battery. Refer to INSTALLATION PROCEDURE .
- Lock clips (2) from the battery vent tube (1).
- Install the battery vent tube (1) to the upper radiator air deflector (3).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.