Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUZUKI2013SX4 CROSSOVER, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 11 (CHARGING SYSTEM)DIAGNOSTIC INFORMATION AND PROCEDURESSCAN TOOL DATA LIST - ENGINE ELECTRICALENGINE CONTROL MODULE (ECM)
2013 Suzuki SX4 Crossover, Automatic CVT Trans
Engine Control Module (ECM)
2013 Suzuki SX4 Crossover, Automatic CVT TransSECTION Engine Control Module (ECM)
WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.
SCAN TOOL DATA LIST - ENGINE CONTROL MODULE (ECM)
| Scan Tool Parameter | Data List | Units Displayed | Typical Data Value |
|---|---|---|---|
| Ignition ON / Engine OFF | |||
| Crank Request Signal | Electrical / Theft Data | Yes / No | No |
| GEN F-Terminal Signal | Electrical / Theft Data | % | 0% |
| GEN L-Terminal Signal | Command Electrical / Theft | Data ON / OFF | OFF |
| GEN L-Terminal Circuit Status | Electrical / Theft Data | Incomplete / Short Gnd / Open / Short to B+ / OK | OK |
| Ignition 1 Signal | Electrical / Theft Data | Volts | Varies |
| PNP Switch | Electrical / Theft Data | Park / Neutral / In Gear | Park |
| Starter Relay Command | Electrical / Theft Data | On / Off | Off |
| Starter Relay Circuit Status | Electrical / Theft Data | Incomplete / Short Gnd / Open / Short to B+ / OK | OK |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.