Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSSUZUKI2013SX4 CROSSOVER, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 104 (POWER ASSISTED STEERING SYSTEM (ELECTRIC))REPAIR INSTRUCTIONSP/S CONTROL MODULE REMOVAL AND INSTALLATIONREMOVAL

2013 Suzuki SX4 Crossover, Automatic CVT Trans

P/S Control Module Removal and Installation: Removal

2013 Suzuki SX4 Crossover, Automatic CVT TransSECTION Removal

WARNING: This page is about a different car, the 2011 Suzuki SX4. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect negative cable at battery.
Remove console box.
Disconnect connectors (1) from P/S control module.
Remove P/S control module (2) and bracket from floor panel.

Fig 1: Identifying P/S Control Module And Connectors
Courtesy of SUZUKI OF AMERICA CORP.
Separate P/S control module and bracket.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.