Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUZUKI2013SX4 CROSSOVER, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 103 (TIRE PRESSURE MONITORING SYSTEM)REPAIR INSTRUCTIONSREGISTRATION PROCEDURE FOR TIRE PRESSURE SENSOR ID CODEUSING SUZUKI SCAN TOOL
2013 Suzuki SX4 Crossover, Automatic CVT Trans
Using SUZUKI scan tool
2013 Suzuki SX4 Crossover, Automatic CVT TransSECTION Using SUZUKI scan tool
WARNING: This page is about a different car, the 2011 Suzuki SX4. However, it is still accessible from the selected car via links, so may be relevant.
- Turn ignition switch to OFF position.
- Connect SUZUKI scan tool to data link connector (DLC) (1) located on underside of instrument panel at driver's seat side.
Special Tool
(A): SUZUKI scan tool (SUZUKI-SDT)
- Turn ignition switch to ON position.
- Select "TPMS ID registration with LF tool" of "MISC TEST" under "BCM" mode of SUZUKI scan tool.
- Activate each tire pressure sensor according to the instructions displayed on SUZUKI scan tool within 90 seconds.NOTE:
- When tire pressure sensor is to be activated, set the special tool to the same position as shown in the illustration below. If the special tool is set to other positions, there is a possibility that tire pressure sensor cannot be activated.
- When tire pressure sensor is activated, flashing LED and beeping sound of special tool indicate an activation of the tire pressure sensor. In case that LED does not flash and beeping sound is not heard even if special tool is normal, replace faulty tire pressure sensor.
- When tire pressure sensor is activated, ID code of the tire pressure sensor is registered automatically in BCM.
- When "ID Code Regi Status" indicated on SUZUKI scan tool is "Complete", registration has been completed. If "Timeout" is indicated, perform the registration procedure all over. Also, it is possible to check the number of ID codes of tire pressure sensors received by BCM by observing the flashing pattern of the low tire pressure warning light.
- When BCM receives each ID code of 4 tire pressure sensors, BCM turns ON low tire pressure warning light in combination meter for 5 seconds.
Special Tool
(B): 09945-86510
#1, #2, #3 and #4 ID Regi status (ID registration status)
- Complete: Indicates that only when BCM has received the ID code of the tire pressure sensor
- Incomplete: Indicates that BCM has not received the ID code of the tire pressure sensor
ID code Regi status (ID code registration status)
- Complete: Indicates that only when the ID code of each tire pressure sensor has been registered in BCM within a specified work time
- Incomplete: Indicates that BCM has not received the ID code of the each tire pressure sensor
- Turn ignition switch OFF position and then disconnect SUZUKI scan tool from DLC.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.