SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUZUKI2013SX4 CROSSOVER, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 103 (TIRE PRESSURE MONITORING SYSTEM)REPAIR INSTRUCTIONSREGISTRATION PROCEDURE FOR TIRE PRESSURE SENSOR ID CODENOT USING SUZUKI SCAN TOOL
2013 Suzuki SX4 Crossover, Automatic CVT Trans

Not using SUZUKI scan tool

2013 Suzuki SX4 Crossover, Automatic CVT TransSECTION Not using SUZUKI scan tool
WARNING: This page is about a different car, the 2011 Suzuki SX4. However, it is still accessible from the selected car via links, so may be relevant.
  1. Confirm that all doors are closed and ignition key is out of ignition key cylinder.
  2. Open driver side door.
  3. Perform the following Steps  a) to  c) within 15 seconds after ignition switch turned ON.
    1. Press driver side door switch hand within 5 seconds after ignition switch turned ON. Keep the switch pressed for 2 seconds.
    2. Release driver side door switch and then press driver side door switch for 2 seconds or more by hand.
    3. Release driver side door switch and then press driver side door switch for 2 to 5 seconds by hand.
      Fig 1: Tire Pressure Sensor ID Code Registration Procedure Timing Pattern
      G06869238Courtesy of SUZUKI OF AMERICA CORP.
  4. Using special tool, activate each tire pressure sensor within 90 seconds.

    Refer to the instruction of special tool for the method of activating tire pressure sensor.

    NOTE:
    • When tire pressure sensor is to be activated, set the special tool to the same position as shown in the illustration below. If the special tool is set to other positions, there is a possibility that tire pressure sensor cannot be activated.
    • When tire pressure sensor is activated, flashing LED and beeping sound of special tool indicate an activation of the tire pressure sensor. In case that LED does not flash and beeping sound is not heard even if special tool is normal, replace faulty tire pressure sensor.
    • When tire pressure sensor is activated, ID code of the tire pressure sensor is registered automatically in BCM.
    • If each ID code of 4 tire pressure sensors is not registered in BCM within 90 seconds, start all over from Step  1). Also, it is possible to check the number of ID codes of tire pressure sensors received by BCM by observing the flashing pattern of the low tire pressure warning light.
    • When BCM receives each ID code of 4 tire pressure sensors, BCM turns ON low tire pressure warning light in combination meter for 5 seconds.

    Special Tool 

    (A): 09945-86510 

    Fig 2: Low Tire Pressure Sensor Warning Light Timing Pattern
    G06869239Courtesy of SUZUKI OF AMERICA CORP.
  5. After registration is completed, turn ignition switch to OFF position.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.