SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUZUKI2013SX4 CROSSOVER, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 10 (DATA COMMUNICATION SYSTEM)DIAGNOSTIC INFORMATION & PROCEDURESPOWER MODE MISMATCHDIAGNOSTIC FAULT INFORMATION
2013 Suzuki SX4 Crossover, Automatic CVT Trans

Diagnostic Fault Information

2013 Suzuki SX4 Crossover, Automatic CVT TransSECTION Diagnostic Fault Information
WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.
DIAGNOSTIC FAULT INFORMATION

Circuit Short to Ground Open/High Resistance Short to Voltage Signal Performance
Accessory Voltage  1(2)  1  1 -
Ignition 1 Voltage  1(2)  1  1 -
Off/Run Crank Voltage  1(2)  1  1 -
Ignition Key Resistor Signal  1  1  1 -
Accessory Wakeup Serial Data DTC U1814(1) DTC U0100-U0299, P0513 00 - -
Ignition 1 Voltage (Between BCM and IGN MAIN relay 31) DTC B1428(1)  2  3 -
Battery Positive Voltage (Ignition switch)  1(2)  1 - -
  1. Power Mode Mismatch. Different specific symptoms may occur depending on the vehicle operating conditions when the fault occurred.
  2. Vehicle will not start and will set DTC B1370 06 in SIR.
  3. The engine will continue to run after ignition key is removed.
(1) This circuit is a pass through circuit in the BCM and will cause Ign Switch fuse to open.
(2) This circuit/condition will cause Ign Switch fuse to open, and may cause a no start condition.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.