Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUZUKI2013SX4 CROSSOVER, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 10 (DATA COMMUNICATION SYSTEM)DIAGNOSTIC INFORMATION & PROCEDURESDTC B1001CIRCUIT/SYSTEM VERIFICATION
2013 Suzuki SX4 Crossover, Automatic CVT Trans
Circuit/System Verification
2013 Suzuki SX4 Crossover, Automatic CVT TransSECTION Circuit/System Verification
WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.
B1001 00
Program the body control module (BCM). Refer to Service Programming System (SPS)
- If the DTC remains current, replace the BCM.
B1001 45
- Program the restraints ID into the BCM.
- Retrieve DTCs from the BCM. DTC B1001 45 should change to a history DTC.
- If the DTC remains current, replace the BCM.
B1001 4B
- Program the tire/axle RPO into the BCM.
- Retrieve DTCs from the BCM. DTC B1001 4B should change to a history DTC.
- If the DTC remains current, replace the BCM.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.