SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUZUKI2013SX4 CROSSOVER, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSISENGINE PERFORMANCETESTING & DIAGNOSISENGINE GENERAL INFORMATION & DIAGNOSISDIAGNOSTIC INFORMATION AND PROCEDURESENGINE AND EMISSION CONTROL SYSTEM CHECKNOTES
2013 Suzuki SX4 Crossover, Automatic CVT Trans

Engine and Emission Control System Check: Notes

2013 Suzuki SX4 Crossover, Automatic CVT TransSECTION Notes
NOTE: Refer to items under checking procedure for details of each step.
DIAGNOSTIC INFORMATION AND PROCEDURES REFERENCE CHART

Step Action YES NO
1  Customer complaint analysis 
  1. Perform customer complaint analysis.

Was customer complaint analysis performed? 		 Go to Step 2. Perform customer complaint analysis.
2  DTC/freeze frame data check, record and clearance 
  1. Check for DTC (current and pending DTC).

Is there any DTC(s)? 		 Print DTC and freeze frame data or write them down and clear them by referring to DTC CLEARANCE , and go to Step 3. Go to Step 4.
3  Visual inspection 
  1. Perform visual inspection.

Is there any faulty condition? 		 Repair or replace faulty part, and go to Step 11. Go to Step 5.
4  Visual inspection 
  1. Perform visual inspection.

Is there any faulty condition? 		 Repair or replace faulty part, and go to Step 11. Go to Step 8.
5  Trouble symptom confirmation 
  1. Confirm trouble symptom.

Is trouble symptom identified? 		 Go to Step 6. Go to Step 7.
6  Rechecking and recording DTC/freeze frame data 
  1. Recheck for DTC (current and pending DTC) and freeze frame data.

Is there any DTC(s)? 		 Go to Step 9. Go to Step 8.
7  Rechecking and recording DTC/freeze frame data 
  1. Recheck for DTC (current and pending DTC) and freeze frame data.

Is there any DTC(s)? 		 Go to Step 9. Go to Step 10.
8  Engine basic inspection and engine symptom diagnosis 
  1. Perform engine basic inspection and engine symptom diagnosis.

Is there any faulty condition? 		 Check and repair faulty part(s), and go to Step 11. Go to Step 10.
9  Troubleshooting for DTC 
  1. Perform troubleshooting for applicable DTC.

Are check and repair complete? 		 Go to Step 11. Check and repair faulty part(s), and go to Step 11.
10  Intermittent problem check 
  1. Check for intermittent problems by referring to "INTERMITTENT PROBLEM CHECK ".

Is there any faulty condition? 		 Repair or replace faulty part(s), and go to Step 11. Go to Step 11.
11  Final confirmation test 
  1. Perform final confirmation test.

Is there any problem symptom, DTC or abnormal condition? 		 Go to Step 6. End.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.