Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUZUKI2013SX4 CROSSOVER, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSISBODY & FRAMEDOOR LOCKSSECURITY & LOCKSDIAGNOSTIC INFORMATION AND PROCEDURESKEYLESS ENTRY SYSTEM OPERATION INSPECTION (IF EQUIPPED)
2013 Suzuki SX4 Crossover, Automatic CVT Trans
Keyless Entry System Operation Inspection (If Equipped)
2013 Suzuki SX4 Crossover, Automatic CVT TransSECTION Keyless Entry System Operation Inspection (If Equipped)
NOTE:
When performing the this inspection, make sure to have any of the door once opened/closed after the ignition key has been removed from the ignition key cylinder.
- Confirm that power door lock system operates normally, refer to POWER DOOR LOCK SYSTEM OPERATION INSPECTION .
- All doors are closed and unlocked.
- Check the following operation:
- Push "lock" button (1) on transmitter (2) or remote controller once, and check all doors lock and hazard waning lights flash once.
- Push "unlock" button (3) on transmitter (2) or remote controller twice, and check all doors unlock and hazard waning lights flash twice and interior light turns on several seconds with the interior light switch in the middle position.
If malfunction is found, go to KEYLESS ENTRY SYSTEM SYMPTOM DIAGNOSIS (IF EQUIPPED) .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.