Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSSUZUKI2013SX4 CROSSOVER, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSISBODY & FRAMEDOOR LOCKSIMMOBILIZER CONTROL SYSTEMDIAGNOSTIC INFORMATION AND PROCEDURESDTC CLEARANCE
2013 Suzuki SX4 Crossover, Automatic CVT Trans
DTC Clearance
2013 Suzuki SX4 Crossover, Automatic CVT TransSECTION DTC Clearance
- Turn the ignition switch to OFF position,
- Connect SUZUKI scan tool to data link connector (DLC) (1) located under instrument panel at driver's seat side.
Special Tool
(A): SUZUKI scan tool (SUZUKI-SDT)
- Turn the ignition switch to ON position.
- Clear DTC(s) according to the instructions displayed on SUZUKI scan tool.
- After completing the clearance, turn the ignition switch to OFF position, and then disconnect SUZUKI scan tool from DLC.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.